Swan SI9030N Instruction Manual download pdf (Page 7)

1. After power On, water tank indicator light will light up for easy viewing of

water level.

2. Water tank indicator light will not light up when water tank or filter are

not properly installed. No steam will be produced even if steam button is pressed.

Water tank indicator light

1. Fill water tank with clean water refer to above filling instruction. For better

performance, please immerse filter in water for several minutes before installing

it into the water tank.

2. Connect the appliance into a suitable socket outlet. Water tank decoration indicator

light lights up to indicate that the unit has been connected to the power supply.

3. Set temp setting knob to steam ironing position according to fabric setting chart

mentioned above. Heating indicator light illuminates to indicate the unit is

being heated up. When the heating indicator light turns off,the desired temperature

has been reached. It is ready for steam ironing. During use, heating indicator light

cycles from on to off, and then off to on. It does not indicate a defects or hazard, it is

just temperature maintenance.(For every first time use,

please pre-heat for 3 minutes)

4. Before every first time use, it is advised to clean iron unit as following methods:

Take the iron up from the base unit, press steam button underneath the handle to

allow steam ON for 20 seconds, and then OFF for 30 seconds, this cycle should be

repeated for 2 times. When temperature indicator light stops blinking, it is ready for

use.

5. After use, put iron unit back onto the base unit again, turn temperature control dial

to“MIN”, and then unplug the appliance from main socket .

6. Slide out the water tank and pour out the remaining water.

Note:

For every first time use, it is normal that’s a slight vibration sound may be

heard from electrical pump inside the base unit for a few seconds when steam

ironing has started. It is because there is air inside the filter, it will stop once

the air inside the filter has been pumped out.

Steam ironing

How to use your steam generator

1 2 3 4 5 6 7 8 9 10 11

No comments

Swan SI9030N Instruction Manual Page 7