Swan SI9030N Instruction Manual download pdf (Page 6)

1. Check if the rating indicated in the rating plate

corresponds to the mains voltage in your home.

2. Press handle button to lay handle down. Fig.1

3. Remove the protective foil or sticker or card from

the soleplate.

4. Fully unwind and straighten the power cord and

the supply hose.

5. Place the appliance on a stable, level and horizontal

surface such as an ironing board.

6. Place the iron onto the iron rest plate horizontally at the base unit.

Prepare the appliance for use:

1. Press the water tank lock upwards and

slide the detachable water tank

outwards from the base.

Fig.2

2. Take the filter upwards out from the

water fill hole.

Fig.3

3. Fill the water tank up to or below the

“MAX” fill line with clean tap water. Fig.4

4. Replace filter back into water filling hole.

5. Replace the water tank into the base

unit again. It will be locked in place with

the base unit until a “click” sound is

heard.(Water tank

indicator light will light up to indicate that

water tank and filter have been installed

in place if power ON) Fig.5

6. Always pour out the remaining water

after use.

Note: When the water level reaches a low

level or empty, pump sound will change

to indicate refilling is needed. Stop using

the appliance immediately and refill

water tank as the above methods.

Fill water tank

How to use your steam station

Fig.1

Fig.2

Fig.3 Fig.4

Fig.5

1 2 3 4 5 6 7 8 9 10 11

No comments

Swan SI9030N Instruction Manual Page 6