5. Apron Strips
TW-32 Only
If the distance from back wall to front
edge of apron is more than 31-1/2",
the apron strips will not line up with
the side wall, and must be cut down or
discarded if a straight line from floor to
top of the side panel is desired.
7. Trial fit before
proceeding.
Use a drill and a hole-cutting bit, or a
hole saw, to cut your holes 1/2" larger
than the diameter of the pipes. Drill or
cut from the finished side of panel.
For best results, place a scrap of wood
beneath hole to be cut. This gives you
a clean opening.
6A. Side Panels
TW-32 Only
Note: Side panels for Model TW-32, A
and E, are not interchangeable. Check
backs for markings left and right.
Measure location of plumbing outlets
from a line straight up from front edge
of apron strips (or tub, if strips are not
used) and height above top ledge of
the tub. We suggest you make a tem-
plate from cardboard to help position
your side panel over plumbing outlets.
Transfer measurements to panel mak-
ing sure (before you drill) that you
have selected the correct panel.
6B. Side Panels
WW-6000 Only
Measure location of plumbing outlets
from the front edge of the tub (A) and
up from the top of the tub (B). We
suggest you make a template from
cardboard to help position your side
panel over plumbing outlets.
Transfer measurements to panel mak-
ing sure (before you drill) that you
have selected the correct panel.
8.
Apply adhesive to proper side panel
with pattern suggested. Keep adhesive
1" away from factory applied pressure
sensitive tape. Put an extra ring of
adhesive around drilled holes.
Remove the backing from the factory
applied pressure sensitive tape.
9.
Carefully line up front edge of panel
with front edge of apron strip (or tub,
if strips are not used) with bottom
edge resting on the top ledge of the
tub. Press firmly starting from bottom
and continuing up to insure solid wall
contact.
CAULKING
Following instructions on the caulking
tube…apply a bead of caulking along
the bottom and top edge of the back
panel, side panels and corner panels.
The center panel’s two lapping edges
and the two overlapping edges of the
side panels may also be caulked, if
desired, however, it is NOT necessary.
CARE AND CLEANING
The surface is stain and abrasion resistant, however it requires reasonable care.
Wash regularly with warm water; use soft cloth with mild liquid detergent such as
Handy Andy, Mr. Clean or Lestoil. Scouring pads made of nylon, saran or polyethyl-
ene may be used but NEVER USE ABRASIVE SCOURING POWDERS, CLEANERS OR
PADS…THEY DULL THE FINISH. Protect finish with any fiberglass wax or automotive
paste wax.
CAUTION:
Dry cleaning agents and solvent will damage the surface. Burning
cigarettes will damage and discolor surface.
FORM #875-10-03-5M
The Swan Corporation One City Centre Suite 2300 St. Louis, MO 63101
p
(800) 325-7008
f
(314) 231-8165
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals