Swan SK13130N Service Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
HOW TO USE
BEFORE FIRST USE
Check that all accessories are complete and the unit is not damaged. Add water into
water tank to the max level and brew water several times without coffee powder, then
discard the water. Clean all detachable parts thoroughly with warm water.
USING YOUR COFFEE MAKER
1. Open the lid and fill the water tank with water. The water level should not exceed
MAX level marked inside the tank.
2. Place the filter into the coffee maker ensuring correct fitting
3. Add coffee powder into filter. Usually a cup of coffee needs a level spoon of coffee
powder, but you may adjust according to personal taste. Then close the lid.
4. Insert the carafe on keep warm plate.
5. Plug the power cord into the outlet. The LCD will display “12:00” and the colon will
flash, but all the button lights will not illuminate.
6. Press ON/OFF button, the RUN indicator will be illuminated red. The appliance
will begin working.
7. The brewing process can be interrupted by pressing the ON/OFF button twice
again at any time, and the RUN indicator will go out. The appliance will continue
brewing once ON/OFF is pressed again. Note: You can take out carafe, pour and
serve at any time. The appliance will stop dripping automatically. But the time
cannot exceed 30 seconds.
8. Remove carafe to serve when finished brewing (about one minute after the
coffee stops dripping out. Note: the coffee you get will be less than the water you
have added, as some water is absorbed by coffee grounds.
9. When the process is finished, if you do not want to serve immediately, keep
the coffee maker switched on, the coffee can be kept warm on the keep warm
plate. The appliance will cut off the power automatically after two hours if it has
not been manually disconnected at the completion of brewing. For an optimum
coffee taste, serve it just after brewing.
10. Always turn the coffee maker off and disconnect the power supply when not use.
Note: pay attention to pour the coffee carefully to avoid scalding hazard.
AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, for example now
it is 17:10 pm, you want the coffee maker to automatically start at 20:15 in the
evening, first follow steps 1 to 5 of previous section, then you can set the automatic
start function as follows:
SK13130N_IM.indd 4 29/10/2013 13:28
Page view 3
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments